GeoWiki.png
 
The SolarWiki > The Science of Solar > Solar Basics > C. Semiconductors and Solar Interactions > IV. Recombination of Charge Carriers > 3. Auger Recombination

3. Auger Recombination

Table of Contents

There is a physical process known as the impact ionization effect by which a high-energy electron collides with an atom, giving enough energy to one of the atom’s electrons to break its bond and create an electron-hole pair. The Auger effect is just the reverse process of this1; in this type of recombination, the excess energy given off by an electron recombining with a hole is given to a second electron (in either band) instead of just emitting the energy as a photon. The newly excited electron then gives up its additional energy in a series of collisions with the lattice2, relaxing back to the edge of the band. Thus, this effect is a result of interactions between multiple particles, including multiple electrons and a hole. Note: this process can also occur with multiple holes and one electron, depending on whether charge carriers in the valence or conduction band are involved.

Because this process is based on the ability of the charge carriers to exchange energy, the probability of Auger recombination increases with a higher concentration of charge carriers. For an electron-hole-hole process we expect then that the reaction mechanism will be proportional to p2n and for an electron-electron-hole process that it will be proportional to n2p (where n and p are the electron and hole concentrations respectively)2. The recombination rates, RE for electrons and RH for holes, are given by

recomb_rates.png

where B is the Auger coefficient based on the material. Furthermore, we can use the recombination rates to obtain an Auger lifetime τAug for both electrons and holes:

auger_lifetimes.png

There is a form for the lifetimes that include the minority carrier contribution as well, however it is this previous form for the majority carrier of the material that is most prominent. Including the term for the contribution from the minority carrier band, we have

auger_lifetimes2.png

where C is a constant also depending on the material1. The term describing majority carrier behavior has a squared term that indicates effectiveness at very high doping levels. So, only in relatively highly doped semiconductors does Auger recombination become a dominant process, because the lifetime of the carrier becomes much shorter. In many semiconductor devices, the dopant concentrations are less than 1018 cm-3, so it is of lesser significance in most semiconductor devices2; however, under certain conditions, such as highly concentrated sunlight, Auger recombination does significantly limit solar efficiency because of shorter carrier lifetimes.

References

1. Goetzberger, Adolf et.al. Crystalline Silicon Solar Cells. Chichester: John Wiley & Sons Ltd., 1998.

2. Green, Martin A. Solar Cells: Operating Principles, Technology, and System Applications. Englewood Cliffs: Prentice-Hall, Inc., 1982. Full book ordering information at www.pv.unsw.edu.au.

You must to post a comment.
Last Modified
14:20, 17 Dec 2013

Page Rating

Was this article helpful?

Tags

This page has no custom tags set.

Creative Commons License UC Davis SolarWiki by University of California, Davis is licensed under a Creative Commons Attribution-Noncommercial-Share Alike 3.0 United States License. Permissions beyond the scope of this license may be available at copyright@ucdavis.edu. Terms of Use